Inertial dampening field device parts needed:

• A void source of considerable size (a large void battery, a large void crystal, intensely blessed object, etc) (separate from the one used for the antigravity drive)
• Enough copper wire & plating to cover your intended craft
• A set of switches
• A void-inertia converter or
  • About thirty pounds of magnesium that can be slowly fed into sulfuric void
  • Two gallons of sulfuric acid
  • A small void source
  • A moderate source of heat
  • A glass jar that is fire-resistant (not magically)
  • Air tight room
  • Copper wire

Place the void source in the glass jar (remember ACID AFTER--if you place the acid in first, the resultant boil will likely explode violently). Place over heat source. Slowly fill the jar with sulfuric acid. Once full, arrange for the slow feed of magnesium into the jar. Leave room & seal it with lead, but allow one bit of copper wire to connect room to outside.

Connect room to copper plating around vessel via copper wiring. Connect large void source to converter via copper wiring. Place switches between plating & converter & between converter & large void source.

The large source will funnel void through the converter, which will change the nature of the void to null-inertia. The converted energy will flow from the converter to the plates, which will slowly discharge the energy, whree it will null the inertia. The switches allow the control of the flow of energies.