Friction dampening field device parts needed:

• A moderate source of void
• Enough copper wire & plating to cover your intended craft
• A set of switches
• A void-friction converter or
  • About thirty pounds of titanium that can be slowly fed into carbonic void
  • Two gallons of carbonic acid
  • A small void source
  • A moderate source of heat
  • A glass jar that is fire-resistant (not magically)
  • Air tight room
  • Copper wire

Place the void source in the glass jar (remember ACID AFTER--if you place the acid in first, the resultant boil will likely explode violently). Place over heat source. Slowly fill the jar with carbonic acid. Once full, arrange for the slow feed of titanium into the jar. Leave room & seal it with lead, but allow one bit of copper wire to connect room to outside.

Connect room to copper plating around vessel via copper wiring. Connect void source to converter via copper wiring. Place switches between plating & converter & between converter & void source.

The moderate source will funnel void through the converter, which will change the nature of the void to null-friction. The converted energy will flow from the converter to the plates, which will slowly discharge the energy, whree it will null the friction. The switches allow the control of the flow of energies.